 |
|
 |
Begin OCR Text:
P _ 2O, P _ 8OO
bo_i íoin_g gbou_d be ingpe_1ed ond _epioced iF boll ioint o1tochment with o hommer ond
necessory obout once o yeor. When Fitting o new dolly.
rubber seol, this should be filled with chossis _. fi_1jng ig done in 1he reverge order. The cost_
greose. Ie nut is 1ightened to o torque oF _.8-5.5
on bo_i __o_,n1, w_i1bou1 greoge n__pp_eg. 1be boi_ kgm (3f-_O Ib.ft.). Fill greose between the
g1ud bog o _ , _,_-2o u_F 1breod compored w_j1b rubber pro1ector ond bol_ ioin1. Air_vent the
on _ _ 2 x _ ._ 1breod for bo_i __o__n1g w_i1b greQge wbegi uni1 cyiinderg in cogeg where the
n__ppieg. _berefore mo_e gure 1bo1 1be correc1 nu1 broke line hos been removed. .
is used when repIocing o boIl ioint,
1 . Remove the hub cop ond slocken 1he wheel _epl__i_g the upper wishbo_e bu$hes
nuts slightly_ _ . Remove 1he hub cop ond slocken the wheel
2. lock up the front end ond ploce o block nuts slightly.
under the lower wishbone. Unscrew the 2. _ock up 1be fron1 end ond pioce o block
wheel nuts ond liF1 off the wheel_ under 1be _ower wigbbone unscrew the
_ i _
3. Ungcrew 1be nu1g ond remOve the fOUr bOltg Wheel n Utg ond l_ft Off the Whee .
(_ 8. Fig. l O). Remove the split pin C22) ond 3. _crew off 1be nu1g (3. Fig. _ _ ) ond remove
nut (2l ). the c_ompg (J).
4. _end bock the locking wosher, screw ouf
the ot1oching bolts ond reMove the shoft _
(9). Toke core of the shi Ms.
5. Remove the nuts (5). woshers (d) ond bushes
(6) with sleeves (8).
6. Fit 1he new rubber bushes (_) ond sleeves
(8) on to the wishbone shoft (9),
in order to foci_i1ote fit1ing it is odvisoble to
use soop solu1iDn os Iubricont_
fi1 the woshers (4) ond 1ighten the nuts (57_
Then ottoch the wishbone with clomps loo_
sely on the two bushes.
_. Fit 1be ghimg ond g$cure the shoft (9) ond
wishbone. Tigbten the ottoching bolts (_ .
Fig. _) to o 1orque of 4.8 5.5 kgm (35-dO
Ib.ft.) ond lock them with the tobs on the _
Iocking plo1e (2).
g. Tighten 1he ottoching nuts (3. fig. _ l ) for
,vo the clomps to o torque of 2-2.5 kgm |
