 |
|
 |
Begin OCR Text:
P 1 8OO
VOlVo vo_vo
2_l73 ii_,___
F__g. 3_. F______ng gnd _ap ove_ ge_e__o_ _a_i_ Fi9_ 33, Fitt_ing interlock balls and springs
_ A = approK. Q mm (5/32 _)
_ 5. Place the main shaft in the housing. Turn viously. that is to say, the centre end cap
the rear couer so that the countershaFt should project about 4 mm (5/32 '') outside
can be fitted. the face of the housing, see Fia. 32.
6. Turn the gearboK upside down. Fit the 9. GearboKes with ouerdrive .
countershaft from the rear. Hold against __urn the cover correctly so that it locks the
SVO 23O3 with the hand. Ensure that the reverse shaft (early prod.) . Ensure that the
thrust washers do not loosen and fall down. eccentric for the overdrive oiI pump is
7. Gearboxes without overdrive . turned upwards. Fit the overdrive unit.
Turn the rear couer correctIy so that it Iocks Use new washers for the spacer fIange.
the reverse shaft (early prod.) . Fit the bolts 1 O. PIace the i nterlock balls and springs in
for the cover. position, see F_ig. 32. Fit the gearboK cover.
8. Fit selector rails and forks. Move over the Check that all gears engage and disengage
_ selector fork to the rear position when freely.
_ _ fitting the pin. use a new pin. Fit the casing
_ ouer the selector raiIs. F___ _
_ote. _f the end caps _n thg front end of G
the housing have been remoued, these Fitting is done in the reverse order to removing.
_ should be fitted in the same way as pre- Fill up the gearboK with oil. 4 - 9
|
