 |
|
 |
Begin OCR Text:
_
_
__
_
Q_Hyo _
P 12O_ P 18OO
, . F_g_ 8_ M$_king th$ tlutth caSing and p_$aSU_e plat8
__
. l_pvt shoh gvide beoring in the _l_heel
' The bearing is pulled out with puller SVO 4O9O,
see Fig. 7. .
__ _ If the flywheel has been removed, the bearing
can be driven outwith drift SVO 1426.
_ The bearing should be cleaned in petrol (gas-
olinB). If the bearing, upon 'inspection. runs
k smoothly and 8venly and has no noticeable play,
it should be packed with ball bearing grease and
_ ref___ed N _ Heat reg__gtant greage ghou_d be
____ _ _ _ -
Fig_ 8_ Clut_h dist used.
1. Facings 2. Hub 3. Spring 4, DiSC The bear__ng _ig pregged __n w__th dr__ft Svo _ _
from the side on which the facing Iies and
riveted up from the opposite 4reGtion against Di__ont_i_g
the disc. Use evey other hole i_ the f8cing. __u__H w__H _o__ _p_____
After riveting, the facings should be spaced
from each other as determined by the inden- 1. Mark the clufcf ae shown in Fig. 8 if this has
tations on the clutch disc. S8e Fig. 6. This is not been done p_r$viously.
most important in order to achieve a smooth 2.. PIace the packi_ blocks No. _O on fiKt.u_
_ engagement when starting and driv'ing. _ _ S__
.322, see Fig. 9. Plac'e'on th$ clutG __ the.
The clutch facings must be absolutely free____ __- .-upports, the arms andth.$ thrae tfrust
. _ _
_1 _ 1 ___ _
Fig. a. Plating the clutth in th$ fi_ra, l
Fig_ 7_ R$moving th$ gu_d$ _earing 1. Packing block No. O 4_3
|
