 |
|
 |
Begin OCR Text:
P 18OO
l2 vo_vo _h
_2_856_
Fig. 76. Fittíng the breaker c8msf8ft
1. Place the ResiteK plate on the distributor shaft _
and the fibre washers above this, s3e Fig. 74.
Lubricate and place the centrifugal governor
weighfs in position. Fit the locking springs.
VoCW 2 Fit the b_eaker çamsha_ and p_açe on ehe
_ _l_fl ' springs, see Fig. 76.
3. Lubricate the distribul_or shaft and place it in
Fig. 7f. LUbr_C8tín0 Stheme for distribUtor _h d_ t _b e h _ _h k eh i eh _ _
e IS rl U Of OUStng. eC a e aKta
(Lubrícant Bosch or eqUiv8lent) d. . h . . d _
a 3UStlng WaS erS are pOSltlOne COrreCty.
1. Grease the spring lightly Ft 1 v 4
2. Grease the bush and bearing pin Ft 1 v 22
3. Oil the breaker plate sliding surfaces Ol 1 v 22
4. Soak the lubricafing wick with oil Ol l v 2
5. Coat a thin layer of grease on the cam surface
Ft l v 4 _
6. Grease the end of the shaft Iightly and oil with _
Ft l v 8 and Ol l v 2
7. Grease the bearing pins and spring attachments
Ft I v 8
8. Fill the oil cup while turning the shaft Ol l v 13 _
9. Oil the washers and pin before fitting Ol l v 13 _
1O. Soak the lubricating wick between the bushes
with oil Ol l v 13
11. Lubric8te the shaft and fibre washers with gre8se
and oil Ft l v 22 and OI l v 13
12. Oil the regulator plate Ol l v 22
13. Lightly coat the contact surfaces, flange pins etc.
Ft l v B
14. Lubricate the bearing pin, ball, guide líp and con-
tact surfaces with plenty of grease Ft 1 v 22 _ WCW
15. Apply a little grease to the rivet side of the lift- zl_s_
ing lip Ft l v 4 Fig. l7, Fitting the breaker plate
3-32
|
